People can use their credentials to access floors on multiple elevators in the facility.

For this to happen, any reader in the system can be configured as a dedicated elevator device that controls:

• Which floors elevators may go to.

• Which floors people may access.

Examples of 16-floor elevator configurations:

• Use both LS2-ELEM-2220 onboard readers with a single Output Interface to create 2 elevators. The elevators provide 8 + 8 floors (16 buttons).

• Use the LS2-ELEM-2210 onboard reader and LS2-ELEM-1320* dual readers with a single LS2-ELEM-1200 to create 3 elevators. The elevators provide 6 + 6 + 4 floors (16 buttons). In this example the elevators go to the some of the same floors. The first elevator goes to floors 1 - 6, the second to floors 6 - 11, and the third to floors 11 - 14.
  * The outputs on the LS2-ELEM-1320 board do not currently support elevators. Therefore, only use LS2-ELEM-1200 outputs for LS2-ELEM-1320 elevator configurations.

For elevators with more than 16 floors:

Multiple Output Interfaces (LS2-ELEM-1200s) are used. In such configurations, the Output Interfaces associated with an elevator cab cannot be shared with other cab configurations.

Training videos:

• Configure One Elevator, 10 Floors Total

• Configure Two Elevators, 15 Floors Total

• Configure Three Elevators, 35 Floors Total

Related Information

Maximum elevator assignments

_{© 2026 Honeywell International Inc. All Rights Reserved.}